Description
Stage6 Throttle Cable for quick-action throttle CNC 1970mm, spare throttle grip for Stage6 CNC throttle.
As a matter of course we carry all necessary spare parts for Stage6 tuning products. The cable of the CNC quick-action throttle can snap or break off. If this happens, you can replace the cable for small money instead of buying the complete throttle grip. With sleeve and nipple.
Wire length: 2m.
Throttle cable for motorcycle, scooter, moped
The throttle cable is a Bowden cable; it consists of a flexible inner cable made of steel wire, which is protected by a protective sleeve. One end is attached to the throttle grip on the handlebar, while the other end is connected to the carburetor.
How does a Throttle cable work?
When you use the throttle grip, the inner cable moves inside the sleeve and transmits the movement to the carburetor slide or injector. This regulates the amount of fuel or air that enters the engine, controlling the speed and acceleration of the vehicle.
Some two-wheelers are equipped with an oil pump, which is also connected through the throttle cable by a splitter.
Changing the throttle cable
Changing the throttle cable is relatively easy, you only need a few tools. The steps are as follows:
- Dismount the throttle grip, fully releasing the cable tensioner and removing the cable clamp.
- Remove the fairing to access the cable.
- Disconnect the cable end and pull it off the throttle slide.
- Install the new cable using the same steps in reverse order. Remember to lubricate the cable.
- If the two-wheeler is equipped with a cable splitter, you can replace several or all of the cables.
| Throttle Cable Stage6 for quick-action throttle CNC 1970mm | |
|---|---|
| Article no. | S6-SSP110ET01 |
| EAN | 4051272237805 |
| Weight | 0,19 kg |
| Brand | Stage6 |
| Product type | Throttle cable |
