Description
Intake manifold with rubber boot Peugeot moped
Intake manifold short 3D powder print with rubber sleeve Doppler Peugeot 103 MVL / SP.
Something different: the intake manifold was produced using the 3D powder printing process, a type of laser sintering. This process enables a very precise design of the intake tract.
3D intake manifold Peugeot 103
- 1x 3D intake manifold
- 1x rubber boot with clamp
- 4x screws + 4x washers
ATTENTION: As the material used is sensitive to excessive tightening, it is essential not to exceed the tightening torque (4Nm) and not to forget to use the washers. If, contrary to expectations, the part is not completely tight, it is better to use a little sealant instead of overtightening the screws.
Suitable for carburetors with 24mm and 25mm connection
- Dellorto 12-21mm type PHVA / PHBN / PHBG
- Polini CP 17.5-21mm (25mm connection)
- Gurtner and Weber 12-16mm
- TK and China 2-stroke 12-16mm
- Arreche 16-21mm
Note: The connection is measured on the carburetor. Rubber mounts are often slightly smaller, as the rubber expands during installation.
Intake manifold for scooters, motorcycles, and mopeds
The intake manifold is an essential part of the intake system, it directs the air-fuel mixture to the cylinder. Here are the main types of intake manifolds:
Intake manifold with rubber flange
Intake manifolds with flexible intake rubber are the most common type. Flexible materials such as rubber or silicone absors the vibrations of the engine. This flexibility reduces the risk of cracks or leaks. In addition, the flexible mounting makes it easy to adapt the intake manifold to different engine setups.
Intake manifold with metal flange
These rigid-mount intake manifolds are more commonly used on vintage scooters, classic motorcycles or old mopeds. The intake flange is usually made of metal, which provides greater strength and resistance to deformation. Rigidmetal flange assembly also ensures more precise alignment between intake manifold and carburetor.
Swivel intake manifold
Rotatable intake manifolds are commonly used on 50cc motorcycles. They offer greater flexibility in installation, allowing to align the carburetor to meet individual needs.
Note: The diameter of the intake manifold must fit the intake manifold connection width of the carburetor!
| Intake Manifold short 3D print 24mm Doppler Peugeot 103 MVL / SP | |
|---|---|
| Article no. | CGN516867 |
| EAN | 3663829159167 |
| Weight | 0,10 kg |
| Series | ER3 |
| Brand | Doppler |
| Product type | Intake manifold |
| Manifold connection | 24mm, 25,5mm, 25mm |