Part Load Needle 09 w/ clip, slide + spring 16N1-8 Carb Simson
This product is no longer available
Unfortunately, we no longer sell this product in our shop.
However, we would like to help you find an alternative. Please take a look at other products within the same category or contact us so we can help you find the right product.
Description
Part Load Needle 09 w/ clip, slide + spring 16N1-8 Carb Simson S50
We now carry a wide range of interesting parts for fans and lovers of vintage mopeds and scooters. Many parts that have not been available for a long time are now being produced again so you can give your beloved moped a new lease of life.
Carburetor needle
Although it is relatively rare, sometimes you need to change the carburetor needle to fine-tune the carburetor. In most cases, it is sufficient to change the position of the needle to optimize the settings.
The position of the needle mainly affects engine behavior in the partial load range (1/4 to 3/4 throttle).
The thickness of the needle affects the entire rpm range. Thinner needles lead to richer mixture, thicker ones will lean out the mixture.
When adjusting the carburetor, it's a good idea to experiment a bit, preferably ordering a box of main jets (full throttle range), a box of pilot jets (mixture at low rpm) and a box of needles.
| Part Load Needle 09 w/ clip, slide + spring 16N1-8 Carb Simson | |
|---|---|
| Article no. | MOF-41565 |
| EAN | 4057237625601 |
| Weight | 0,04 kg |
| Brand | Standard Parts |
| Product type | Carburetor needle |