Description
Throttle cable for Stage6 CNC quick-action throttle
Stage6 throttle cable for Stage6 CNC Type throttle set, length 1970 mm, replacement part for the Stage6 quick-action throttle.
All spare parts for the Stage6 tuning range are available. The throttle cable of the CNC quick-action throttle can tear or break. Simply replace the throttle cable (with sheath and nipple), there is no need to replace the complete throttle.
- Throttle cable length: 2 meters.
Throttle cable for motorcycle, scooter, moped
The throttle cable is a Bowden cable; it consists of a flexible inner cable made of steel wire, which is protected by a protective sleeve. One end is attached to the throttle grip on the handlebar, while the other end is connected to the carburetor.
How does a Throttle cable work?
When you use the throttle grip, the inner cable moves inside the sleeve and transmits the movement to the carburetor slide or injector. This regulates the amount of fuel or air that enters the engine, controlling the speed and acceleration of the vehicle.
Some two-wheelers are equipped with an oil pump, which is also connected through the throttle cable by a splitter.
Changing the throttle cable
Changing the throttle cable is relatively easy, you only need a few tools. The steps are as follows:
- Dismount the throttle grip, fully releasing the cable tensioner and removing the cable clamp.
- Remove the fairing to access the cable.
- Disconnect the cable end and pull it off the throttle slide.
- Install the new cable using the same steps in reverse order. Remember to lubricate the cable.
- If the two-wheeler is equipped with a cable splitter, you can replace several or all of the cables.
| Throttle Cable for Stage6 quick-action throttle 1970mm | |
|---|---|
| Article no. | S6-SSP110ET01 |
| EAN | 4051272237805 |
| Weight | 0,19 kg |
| Brand | Stage6 |
| Product type | Throttle cable |
