Description
Direct throttle cable Yamaha BW's / Slider
Racing throttle cable (without oil pump cable) for Yamaha BW's / Slider. Connects directly to the carburetor (without splitter). In contrast to the split original cable, this racing throttle cable is a single piece. Ideal for tuning carburetors without an oil connection or tuning projects where the original oil pump is removed.
Particularly recommended for use with PHBG, Polini CP, or PWK carburetors.
Specifications Racing throttle cable
- Length: 155.5 cm
- Diameter: 4.65 mm
- Not split / without splitter
- Racing
- Yamaha BW's / Slider (vertical Minarelli)
Throttle cable for motorcycle, scooter, moped
The throttle cable is a Bowden cable; it consists of a flexible inner cable made of steel wire, which is protected by a protective sleeve. One end is attached to the throttle grip on the handlebar, while the other end is connected to the carburetor.
How does a Throttle cable work?
When you use the throttle grip, the inner cable moves inside the sleeve and transmits the movement to the carburetor slide or injector. This regulates the amount of fuel or air that enters the engine, controlling the speed and acceleration of the vehicle.
Some two-wheelers are equipped with an oil pump, which is also connected through the throttle cable by a splitter.
Changing the throttle cable
Changing the throttle cable is relatively easy, you only need a few tools. The steps are as follows:
- Dismount the throttle grip, fully releasing the cable tensioner and removing the cable clamp.
- Remove the fairing to access the cable.
- Disconnect the cable end and pull it off the throttle slide.
- Install the new cable using the same steps in reverse order. Remember to lubricate the cable.
- If the two-wheeler is equipped with a cable splitter, you can replace several or all of the cables.
| Throttle Cable Racing Yamaha BW's / Slider | |
|---|---|
| Article no. | MF89.20026 |
| EAN | 4260405316731 |
| Weight | 0,15 kg |
| Brand | MotoForce |
| Product type | Throttle cable |
